Everything You Need to Know About Wiring a Diversitech Wet Switch

Wiring a Diversitech Wet Switch is a complex but necessary task for any home or business owner. This type of switch provides an added layer of safety and convenience by allowing you to detect the presence of water and automatically shut off power to devices or systems when it is detected. Knowing how to wire a Diversitech Wet Switch correctly is essential for proper operation and safety.

Required Tools and Preparation

Before attempting to wire a Diversitech Wet Switch, you will need the following tools:

Wire strippers
Cable ties
Electric tape
Screwdriver
Drill
Cordless drill
Permanent marker
Voltmeter
Hammer

When wiring a Diversitech Wet Switch, it is important to take all the necessary safety precautions. Make sure that all power sources are properly disconnected before starting work. It is also recommended to use a voltage tester to confirm there is no power present in the area. Finally, make sure that the installation area is free from standing water and any other potential hazards.

Steps for Installing a Diversitech Wet Switch

Installing a Diversitech Wet Switch requires a few steps. Here is a quick guide on how to do it properly:

Identify the location for the switch. The Diversitech Wet Switch should be installed at least 6 inches above the floor and away from water sources.
Using the drill and screwdriver, connect the mounting bracket to the wall or ceiling.
Connect the power cords according to the manufacturer’s instructions. Make sure that the wires are firmly attached to the switch and that the connections are tight.
Carefully position the switch on the mounting bracket, using the cable ties to keep it secure.
Use a permanent marker to label the switch and indicate which color of wire is connected to which terminal.
Test the switch by turning on the power and placing the switch in the water. If the switch is functioning correctly, it should shut off the power when immersed in water.

Safety Precautions

Using the Switch with AC and DC Systems

The Diversitech Wet Switch is designed to be used with both AC and DC systems. It is compatible with 12, 24, and 120 volt systems, but the recommended voltage rating for the switch is 120 volts. When wiring the switch, it is important to observe all safety precautions and use the appropriate wiring techniques for your system.

Water Detection Technology

The Diversitech Wet Switch utilizes a patented technology called “Smart Water Detection” to detect the presence of water. This technology uses a conductive metal plate to detect the presence of water when it comes into contact with the plate. The switch then automatically turns off the power to the device or system when water is detected.

Ideal Placement for the Switch

When installing the Diversitech Wet Switch, it is important to choose an appropriate location for the switch. It should be placed at least 6 inches above the floor and away from any water sources. It should also be located in a place where it can be easily accessed in case of emergency.

Troubleshooting Tips

If the Diversitech Wet Switch does not seem to be working properly, there are a few troubleshooting tips that can help. Check that the wiring is connected correctly and that the switch is firmly secured in place. Make sure that the switch is not in a location where it could be submerged in water. If the issue persists, contact the manufacturer for further assistance.

Conclusion

Wiring a Diversitech Wet Switch can be a complicated process, but following the correct steps and taking the necessary safety precautions can help ensure that the switch is properly installed and functioning correctly. Knowing how to properly install and use a Diversitech Wet Switch is essential for providing an extra layer of safety and convenience to any home or commercial property.